management¶

Address of the Solidfire API endpoint

This param is used to set the static network config on the Bond1G interface for a Solidfire node before the RTFI process kicks off. You should only fill out this parameter if you do not want the Solidfire appliance to revert to DHCP at the end of the install. This param has the following fields:

address: the IPv4 address to set
netmask: the netmask in dotted quad format.
gateway: the default gateway to use.
dns-nameservers: The nameservers to use. This is a comma-seperated list.
virtualNetworkTag: the VLAN to communicate over.